SW1 L4-1.9L SOHC VIN 8 (1996)
Throttle Body Vacuum Connections
Fuel/Vapor Hose Routing - SOHC
VACUUM HARNESS ASSEMBLY REMOVAL
1. Remove air intake tube and fresh air hose.
2. Disconnect vacuum harness from EVAP canister purge solenoid, and fuel system pressure regulator.
NOTE: The vacuum harness is serviced.
3. Remove vacuum harness from throttle body by unclipping the two tangs and lifting it upward.
INSTALLATION
1. Install the throttle body vacuum harness connector.
2. Connect vacuum harness to EVAP cannister purge solenoid and fuel system pressure regulator.
NOTE: See diagram to insure proper routing and connection of vacuum lines.
3. Install air intake tube and fresh air hose.
4. Start engine and check for vacuum leaks.
