SW1 L4-1.9L SOHC VIN 8 (1996)
23.
Re-wrap inboard side of wiring harness with the gray tape that will ensure that the grommet has been sealed.
IMPORTANT:
Properly wrap the grommet to eliminate any possibility of engine compartment fumes and/or water from entering into the passenger compartment.
IMPORTANT:
If the original gray tape loses its tackiness, a high-quality electrical tape may be used in its place.
24.
Route the replacement wire along the original path of the oxygen sensor wire, from the grommet up to the first harness rosebud retainer location.
25.
Using high-quality electrical tape, wrap the engine wiring harness from the outboard side of the grommet to the first engine wiring harness rosebud
retainer.
IMPORTANT:
The outboard side of the grommet must be taped securely to prevent water from wicking along the replacement wire into the passenger compartment.
26.
Using a sealer such as Kent Industries High Tech Leak Chek Seam Sealer Black (P/N 10070) or equivalent, apply a bead around the entire
diameter of the harness, where it goes into the outboard side of the grommet.
27.
Install grommet into pass-through, making sure it is correctly installed.
