SW1 L4-1.9L SOHC VIN 8 (1996)
12. Twist the stripped, doubled wire and insert into the splice sleeve.
Weather Pack Connectors
Terminal Removal
1. Remove any terminal position assurance (TPA) devices.
2. Insert the weather pack removal tool into the front of the terminal cavity.
Cut Lead Installation
1. Put connector seal on wire and strip approximately 9.5 mm (3/8 in.) off the wire. Caution must be used to prevent cutting the wire strands.
2. Remove insulation from the end of the cut lead and the harness. Recommended strip length is 9.5 mm (3/8 in.). Caution must be used to prevent
cutting the wire strands.
3. Determine proper sleeve for gage wire from the above chart.
4. Position stripped ends in sleeve until wires hit the stop in the center of the splice.
5. Hand crimp using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat.
CAUTION: Do not use match or open flame to apply heat to seal.
6. Apply heat using Ultratorch or some other device, heating to 175 °C (347 °F) until glue flows around edges of sleeve.
7. Check for continuity.
