SW1 L4-1.9L SOHC VIN 8 (1996)
NOTE: The rear heated oxygen sensor uses a permanently attached pigtail and connector. This pigtail should not be removed from the oxygen
sensor. Damage or removal of the pigtail or connector will affect proper operation of the sensor.
INSTALLATION
Rear Oxygen Sensor
1. Install rear heated oxygen sensor using Saturn tool SA9603E.
- Torque: 45 N.m (33 ft-lbs)
NOTE: Always use a nickel-based anti-seize compound (Saturn P/N 2i485279 or equivalent) on the threads of the oxygen sensor. Never use
silicone products; silicone products will damage the oxygen sensor.
NOTE: Make sure to center marker tape with the edge of the trough. The marker tape must be centered with the edge of the trough to ensure
enough slack in the harness.
