SW1 L4-1.9L SOHC VIN 8 (1996)
3. Install cable to control lever and adjust cable.
4. Connect electrical connectors.
Left Side Splash Shield
5. Install left side splash shield.
Wheel Removal And Installation
NOTE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause wheel
lug nuts to loosen in service.
6. Position wheel on hub.
7. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
- Torque: 140 N.m (103 ft-lbs)