SW1 L4-1.9L SOHC VIN 8 (1996)
Electronic Brake Control Module: Service and Repair
1. Record radio presets and disconnect battery ground cable.
2. Remove instrument panel bolt caps, then the upper trim panel screws.
3. Disengage upper trim panel from clips by lifting upward and gently pulling rearward, then remove panel from vehicle.
4. Remove upper trim pad sound insulator, then loosen ABS module mounting nut at transverse beam and lift upward to disengage bracket.
5. Disconnect electrical connectors and remove module.
6. Reverse procedure to install.
CAUTION: Torque mounting nut to 7.4 ft. lbs. Correct torque is critical in order to prevent damage to module.
