SW1 L4-1.9L SOHC VIN 8 (1996)
50.
Install upper trim panel into clips at base of windshield.
IMPORTANT:
Be careful, when removing or replacing upper trim panel, not to damage VIN plate.
51.
Lower panel, making sure upper trim panel alignment tabs interlock with windshield garnish slots.
52.
Push down at clip locations to secure.
53.
Install and tighten screws.
Torque: 2.3 N.m (20 in-lbs)
54.
Install screw caps.
55.
Install AIR BAG fuse to I/P junction block.
56.
Turn ignition switch to the RUN position and verify that the AIR BAG telltale lamp flashes seven times and then turns Off. If it does not operate as
described, perform the "SIR Diagnostic System Check."
