SW1 L4-1.9L SOHC VIN 8 (1996)
2.
Once the connector has been seated, depress connector strain relief housing "Dome" to free up the lock ramps. (The dome is located directly above
the connector lock release.)
3.
While holding the connector strain relief housing dome downward against the connector body, remove connector.
Sensing and Diagnostic Module Connector Assembly
The SDM connector is assembled from basically three parts:
^
The connector body (P/N 12188017) that contains the terminals for all of the SDM wiring.
^
A "clamshell" housing that surrounds the connector body and serves as a terminal position assurance (TPA) device.
^
A tethered connector position assurance (CPA) device (P/N 12191277).
When assembling these three parts, care must be taken to slide the connector body into the "clamshell" housing so that the terminal position provision (1)
is inserted into the connector body. The following connector views illustrate correct and incorrect SDM connector assembly.
