SW1 L4-1.9L SOHC VIN 8 (1996)
2.
On 1991-1995 Sedans, for all three weld nut locations, and on 1996-1999 Sedans for the center weld nut locations:
IMPORTANT:
Illustration shown is for 1991-1995 Sedans, 1996-1999 Sedans are similar.
a.
Locate desired weld nut from under the bottom of the rear window trim finish panel and pierce a hole in the rear window trim finish panel
with and awl.
b.
Leave the awl in the rear window trim finish panel and select a deep well socket with the same outside diameter as the spacer included in the
parts package.
c.
Center the deep well socket over the end of the awl and using a utility knife, trim around the perimeter of the socket. Remove socket and awl
from rear window trim finish panel.
d.
Remove cut-out section of rear window trim finish panel.
3.
On 1996-1999 Sedans, if the desired weld nut is an outer rear window trim finish panel assembly fastener, remove the fastener to expose the
desired weld nut.
Illustration Key
(1) Three Weld Nut Locations
4.
Install child tether anchor bracket, spacer and fastener into appropriate hole.
Torque: 20-30 N.m (15-22 ft-lbs)
5.
Raise rear seat backs.
