SW1 L4-1.9L SOHC VIN 8 (1996)
column support bracket to base of the steering column.
For passenger's side air bag On-Off switch, route Pink wire from air bag On-Off switch assembly over HVAC module following the I/P harness, then
down on driver's side of HVAC module to IPJB.
35.
Cut the Pink wire from the air bag On-Off switch assembly, between the switch and the in-line fuse. Cut the wire close to the in-line fuse to allow
enough wire length to reach the connector replacement pack (P/N 21024610). Discard the in-line fuse.
36.
If installing one air bag On-Off switch assembly:
a.
Using a salmon crimp and seal connector, provided with the connector replacement pack (P/N 21024610), splice the Pink wire from the air
bag On-Off switch assembly to the wire from cavity C of the connector replacement pack.
b.
Tape back unused wire from cavity D of the connector replacement pack (P/N 21024610).
c.
Proceed to step 38.
37.
If installing two air bag On-Off switch assemblies:
a.
Using a salmon crimp and seal connector, provided with the connector replacement pack (P/N 21024610), splice the Pink wire from the
driver's air bag On-Off switch assembly to the wire from cavity C of the connector replacement pack.
b.
Using a salmon crimp and seal connector, provided with the connector replacement pack (P/N 21024610), splice the Pink wire from the
passenger's air bag On-Off switch assembly to the wire from cavity D of the connector replacement pack.
c.
Proceed to step 38.
38.
For 1992-1994 vehicles:
a.
Install wire terminal from cavity A of the connector replacement pack (P/N 21024610), into the IPJB Brown 46-way connector at cavity C7.
b.
Install Brown 46-way connector to IPJB.
For 1995 - 1998 vehicles:
a.
Install wire terminal from cavity A of the connector replacement pack (P/N 21024610), into the IPJB Black 68-way connector at cavity C8.
