SW1 L4-1.9L SOHC VIN 8 (1996)
2.
Determine proper sleeve for gauge of wire. Position stripped ends in sleeve until wires hit stop.
IMPORTANT:
When using the salmon splice sleeve with .35 (22 gage) wire, remove 19 mm (3/4 in.) of insulation. Bend the stripped portion in half to double the
thickness of the wire going into the splice sleeve. Twist the stripped, doubled wire and insert into the splice sleeve.
3.
Hand crimp sleeve using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat to them.
CAUTION:
DO NOT USE A MATCH OR OPEN FLAME TO APPLY HEAT TO SPLICE SLEEVE.
4.
Apply heat using Ultratorch (R) (or equivalent), heating splice sleeve to 175°C (347°F). Heat until glue flows around edges of splice sleeve.
5.
Check for continuity in the wire.
SIR Disable Switch Kit Symptom Diagnosis
