SW1 L4-1.9L SOHC VIN 8 (1996)
NOTICE: The generator shield must be installed to prevent premature generator failures due to foreign debris intrusion.
Generator
1. Position generator on lower cylinder block bracket and install the lower attachment bolt. Install upper attachment bolt and torque both bolts.
Generator Attachment Bolts:
Torque: 32 N.m (24 ft-lbs)
NOTICE: If stud is not held and stud rotates, the plastic insulator will crack and/or break causing generator to fail.
2. Install the generator regulator connector and install the fusible link to the generator. When installing the fusible link use the generator output stud
wrench (SA94OlC) to prevent the output (B+) stud from rotating.
IMPORTANT: The battery terminal fusible link wire(between the starter and generator) should be orientated on the generator between a 10 and
11 o'clock position.
Generator Positive Terminal:
Torque: 10 Nm (89 in-Ibs)
Generator
3. Install the generator splash shield and fastener bolt.
Torque: 10 Nm (89 in-Ibs)
4. Install accessory drive belt.
5. Install side splash shield.
6. Install right wheel.
Torque: 140 Nm (103 ft-lbs)
7. Connect battery negative cable.
Torque: 17 Nm (151 in-Ibs)
