SW1 L4-1.9L SOHC VIN 8 (1996)
9.5
Apply heat using Ultratorch(R) or heat gun. Heat to 175°C (347°F) until glue flows around edges of sleeve.
9.6
Check for continuity in the wire and verify the repair.
10.
Connect transaxle range switch connectors.
NOTICE:
Do not over-tighten or damage to the connector plate may occur.
11.
Connect transaxle electrical connector, and torque transaxle electrical connector bolt.
Torque:
Transaxle Electrical Connector
Bolt: 3 Nm (27 in-lbs)
12.
Clear DTC(s) and retest.
^
If a DTC is reset, refer to diagnostic aids in appropriate model year Automatic Transaxle service manual and continue with next step.
^
If no DTCs are reset, go to step 15.
13.
Clear DTC(s) again.
14.
Check for intermittent circuit fault. Wiggle harness near connector while performing diagnostic tests on affected circuit.
^
If DTC sets, refer to appropriate diagnostic flow chart for circuit number identification. (Refer to appropriate model year Automatic Transaxle
service manual for diagnostic flow charts.) Continue with next step after diagnostics have been completed.
^
If the DTC does riot set, refer to diagnostic aids in appropriate model year Automatic Transaxle service manual for intermittent conditions.
Continue with next step after diagnostics have been completed.
