SW1 L4-1.9L SOHC VIN 8 (1996)
IMPORTANT:
During clutch installation, install flywheel on crankshaft and start bolts. Torque flywheel bolts in a criss-cross pattern as shown in the illustration
below.
Torque: 80 Nm (59 ft-lbs)
NOTICE:
When tightening the clutch housing cover assembly bolts, do not tighten any one bolt more than a half turn at a time or the clutch housing cover
assembly may warp.
Notes:
^
All contact surfaces of the lathe adapters, lathe arbor and flywheel must be clean and free of nicks and burrs.
^
Depth of cut can be aided by a dial indicator.
DISCLAIMER:
We believe these sources and their equipment to be reliable. There may be additional manufacturers of such equipment. Saturn does not endorse, indicate
any preference for, or assume any responsibility for the product or equipment from this firm, or for any such items which may be available from other
sources.
