saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

M/T - Binds Shifting Into or Out of 1st or 2nd Gear|Page 6668 > < M/T - Binds Shifting Into or Out of 1st or 2nd Gear|Page 6662
Page 1
background image

Synchronizer Hub: All Technical Service Bulletins
M/T - Binds Shifting Into or Out of 1st or 2nd Gear

BULLETIN NO.: 96-T-07A

ISSUE DATE: March, 1996

GROUP/SEQ. NO.: Transaxle - 03

CORPORATION NO.: 687203R

SUBJECT: 
Transaxle Intermittently Binds Going Into or Shifting Out of 1st or 2nd Gear, and/or is Stuck in 1st or 2nd Gear - MP2/MP3 Manual Transaxle (Replace
1st or 2nd Driven Gear)

Due to revisions under Parts Requirements, this bulletin supercedes bulletin 96-T-07, which should be discarded.

MODELS AFFECTED: 
1996 Saturns equipped with MP2/MP3 manual transaxles, built between and including VINs TZ213016 and TZ223141.

CONDITION: 
Some customers may comment of a condition in which the manual transaxle intermittently binds going into or out of 1st or 2nd gear, and/or becomes
stuck in 1st or 2nd gear at a stop.

CAUSE: 
These conditions may be caused by damaged 1st or 2nd driven gear clutching teeth. On some vehicles, this condition may cause the synchronizer sleeve
to drag or bind on the clutching teeth, making it difficult to shift into or out of 1st or 2nd gear. In some cases the transaxle could stick in 1st or 2nd gear
at a stop.

CORRECTION: 
Perform the following procedure to diagnose the condition.

PROCEDURE

1.

Start engine and set park brake.

2.

With clutch depressed, shift the transaxle from 1st gear to 2nd gear, and then from 2nd gear to Neutral. Note the effort required for this shift
sequence.

3.

With the transaxle in Neutral, briefly release the clutch pedal and repeat step 2 a number of times. Note the effort required for each shift sequence.

IMPORTANT:

Due to the condition being intermittent, it may be necessary to repeat step 2 a number of times.

4.

If a condition exists at any time in which the transaxle becomes stuck in 1st or 2nd gear, or the effort to shift into or out of 1st or 2nd gear is
significantly higher than normal for a manual transaxle with similar mileage, replace the affected driven gear and inspect the 1st/2nd & Reverse
synchronizer for damage. (Refer to the "1996 Manual Transaxle Service Manual.")

PARTS REQUIREMENTS

CLAIM INFORMATION: 
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System using the appropriate Electronic
Labor Time Guide for the correct Labor Operation Code and Time.

M/T - Binds Shifting Into or Out of 1st or 2nd Gear|Page 6668 > < M/T - Binds Shifting Into or Out of 1st or 2nd Gear|Page 6662