SW1 L4-1.9L SOHC VIN 8 (1996)
3. On manual window vehicles, install manual window regulator handle clip on handle.
Install door handle onto vehicle with handle pointed in a forward and slightly upward position with window closed.
4. Position door handle assembly in trim panel.
Tip handle outward at top. Using a thin hook style tool, lift latch and lock rods into trim panel and slide rearward to engage tabs.
Install screw in handle.
Window Regulator/Motor
REAR DOOR WINDOW REGULATOR/MOTOR
REMOVAL
NOTICE: Do not damage insulator panel when removing regulator.
1. Remove door inner panel. See: Rear Door Trim Panel
2. Lower glass, then disconnect sash from glass by depressing retaining clip tabs and sliding sash off of clips.
3. Remove glass. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Rear Door Glass Replacement
4. Disconnect harness from power regulator.
5. Remove all regulator bolts and slide regulator assembly out of door.
Rotating regulator with the arm pointed downward will ease the removal of the regulator.
INSTALLATION