SW1 L4-1.9L SOHC VIN 8 (1996)
22.
Install the window regulator mounting bolt located closest to counter-balance spring mounting tab wrapped around backing plate.
Only install bolt far enough to remain in backing plate allowing enough clearance for door structure to fit between bolt head and backing plate.
23.
For Manual Windows, continue to step 25.
24.
For Power Windows, route power window wiring harness back into door and secure wiring harness retainer into door structure. Make sure wiring
harness routing is correct so it does not interfere with window regulator movement.
25.
Install window regulator assembly.
^
On 2000 and 2001 models, refer to "Front Door Window Regulator Assembly" installation procedure in the Doors/Windows/Mirrors section
of the 2000/2001 S-Series Body/Electrical (Volume I) service manual.
^
On 1998 and 1999 models, refer to "Window Regulator Assy - Front Door" or "Rear Door Window Regulator/Motor - Sedan/Wagon"
installation procedure in the Doors (BDDR) section of the 98-99 Body/Repair service manual.
^
On 1997 models, refer to "Front Door Window Regulator/Motor" "Rear Door Window Regulator/Motor - Sedan/Wagon" installation
procedure in the Doors (BDDR) section of the 1997 Body/Repair service manual.
^
On 1996 models, refer to "Front Door Window Regulator/Motor - Sedan/Wagon" or "Rear Door Window Regulator/Motor" installation
procedure in the Doors (BDDR) section of the 96 Body/Repair service manual.
IMPORTANT:
When servicing a newer style regulator that has the nuts attached to the backing plate, installation of the washers and nuts is not necessary.
26.
From outside of door structure, install two washers P/N 15650962) and nut (P/N 11508277) to each window regulator bolt and tighten.
