SW1 L4-1.9L SOHC VIN 8 (1996)
8.
Grasp outer edge of applique and lift from liftgate.
9.
Carefully remove inner edge from under liftgate glass encapsulated molding.
10.
Using a small flat blade screwdriver, disengage wiper arm retaining latch.
11.
Remove wiper arm from wiper motor shaft.
12.
From outside of vehicle, trim away encapsulation around the perimeter of liftgate glass using a sharp utility knife.
13.
Using a cold knife No. J24402-A or equivalent, cut urethane adhesive around the perimeter of glass. Keep blade of knife as close to the edge of
glass as possible.
14.
Apply two 152 mm (6 in.) pieces of duct tape to the top and bottom of glass to prevent it from falling out when urethane adhesive is cut.
15.
From inside the liftgate, use a sharp utility knife to cut the remaining urethane at glass corners and areas below the wiper motor shaft.
16.
Remove window assembly.
