SW1 L4-1.9L SOHC VIN 8 (1996)
2.
Remove liftgate side window molding by pulling at clip locations.
3.
Remove fasteners from lower end of liftgate inner lower panel assembly.
4.
Remove liftgate rubber bumper.
5.
Remove liftgate inner lower panel by pulling at clip locations to disengage clips.
6.
Remove fasteners from center high mount stop lamp housing and disconnect wire connector.
7.
Remove electrical connectors from bus bars and rear window defogger. Position electrical connectors so not to damage wiring or connectors when
cutting urethane adhesive.