SW2 L4-1.9L DOHC VIN 7 (1997)
Radio/Stereo: Service and Repair
Removal
Radio Removal
1. Depress center pins inward to release radio/HVAC controller cover push pin fasteners.
Important: Do not push center pins through fasteners.
2. Remove fasteners and pull radio/HVAC controller cover rearward.
3. Disconnect traction control/fog lamp/rear defog electrical connector if equipped.
4. Remove radio screws.
5. Push spring clips in through D holes on both sides of radio brace.
6. Pull radio out slightly to access rear of radio.
Radio Removal
7. Disconnect electrical connector and antenna.
8. Remove radio.
