SW2 L4-1.9L DOHC VIN 7 (1997)
31. Install left and right side splash shields.
IMPORTANT: For left side, install rear section of shield first, then front. For right side, install front section of shield first, then rear.
32. Install tabs in body cut-out.
33. Align molded-in shield fasteners with holes in cradle. Push straight in to install.
34. Install push pins.
IMPORTANT: Make sure shield flaps are tucked in at body locations.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
35. Position wheel onto hub.
36. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
-
Torque: 140 Nm (103 ft. lbs.)
37. Lower vehicle from hoist.
38. Perform vehicle alignment. (Refer to Wheel Tires and Alignment)