SW2 L4-1.9L DOHC VIN 7 (1997)
1.
Place seat back beam onto rear seat back assembly, aligning holes in beam with seat back studs. Snug attaching nuts enough to hold seat back
beam in place.
2.
Latch and unlatch the seat back assembly three to four times to adjust the beam on the rear seat back assembly. Ensure smooth operation.
3.
Tighten attaching nuts.
Torque:
Seat Back Beam Nuts: 18 Nm (13 ft-lbs)
4.
Install seat back beam cover and end caps to seat back beam assembly with new fasteners.