SW2 L4-1.9L DOHC VIN 7 (1997)
e. EGR valve.
12. Disconnect heater and deaeration hoses at intake manifold outlets.
13. Lay harness over brake master cylinder.
14. Remove the intake manifold support bracket bolt attached to the intake manifold located next to the master cylinder.
15. Remove accessory drive belt.
16. Remove power steering pump assembly with support bracket. See Steering and Suspension.
17. Remove the three upper intake manifold attachment nuts.
WARNING: Make sure vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist,
provide additional support for the vehicle on the opposite end from which components are being removed. Make sure hoist does not
contact fuel or brake lines.
18. Raise vehicle squarely on a hoist. Refer to lift instructions for positioning vehicle on hoist.
19. Remove lower power steering unit support bracket.
