SW2 L4-1.9L DOHC VIN 7 (1997)
c. Use RTV cutter tool SA9123E to cut the oil pan seal away from the front cover.
d. Spray the two dowel pin holes (upper left-hand and lower right-hand side of cover) in the cover with penetrating oil to facilitate cover removal
off the dowel pins.
e. Remove the front cover bolts.
f.
Using a screwdriver, pry the front cover away from the cylinder block, using the pry locations shown.
NOTE: The front cover assembly can be removed from under the hood or through the wheel well.
CAUTION: Cover the front of the engine with a shop towel to prevent debris entry into the oil gallery holes and pan. Positioning crankshaft
90 degree off top dead center (TDC) to make sure pistons will not contact valves upon assembly.
