SW2 L4-1.9L DOHC VIN 7 (1997)
2. Install a new gasket on the three way catalytic converter outlet pipe and front pipe/three way catalytic converter assembly.
3. Make sure the three way catalytic converter gasket is properly located and install the three intermediate pipe-to-three way catalytic converter
fasteners. Torque to 31 Nm (23 ft. lbs.).
4. Install the two three way catalytic converter isolators.
5. Install new exhaust pipe to manifold gasket on the studs.
6. Install and torque the exhaust pipe to manifold attachment fasteners. Torque to 31 Nm (23 ft. lbs.).
7. Install the two front exhaust pipe-to-engine stiffener bracket fasteners and slide the clamp rearward, if removed. Torque Front Exhaust Pipe
Support Bracket-to-Engine Stiffener Bracket to 31 Nm (23 ft. lbs.). Torque Clamp-to-Front Exhaust Pipe and Support Bracket to 60 Nm (44 ft.
lbs.).
8. Check the entire exhaust system for leaks.