SW2 L4-1.9L DOHC VIN 7 (1997)
INSTALLATION
1. Install temperature cable over temperature door hook.
2. Snap temperature cable hold down clip over temperature cable holder.
3. Install temperature cable over pin.
4. Install temperature cable housing into channel and push down to lock.
5. Connect blower switch, A/C-Recirc and lighting electrical connectors.
IMPORTANT: Make sure wiring harnesses do not interfere with control lever movement.
6. Install electrical harness clip to module boss.
7. Connect electrical connector and antenna to radio.
8. Install radio.
IMPORTANT: Make sure spring clips are seated in D-holes on both sides.
9. Install and tighten screws.
Torque: 2.5 N.m (22 in-lbs)
10. Connect traction control/fog lamp/rear defog electrical connector, if equipped.
11. Install radio/HVAC controller cover. Push in at clip locations.
12. Install push pins and lock.