SW2 L4-1.9L DOHC VIN 7 (1997)
a. Lubricate O-ring with Saturn R-l2 mineral refrigerant oil.
b. Install line and bolt to TXV.
c. Torque bolt.
Torque: 25 N.m (19 ft-lbs)
WARNING: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL
INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END
FROM WHICH COMPONENTS ARE BEING REMOVED.
9. Raise vehicle.
NOTICE: Use only R-12 Refrigerant oil (mineral) to lubricate O-rings. Use of R-134a (PAG) oil will cause premature corrosion of fitting joints.
10. Remove protective cover and lubricate O-ring with Saturn R-12 mineral refrigerant oil.
11. Connect liquid line to receiver-dehydrator. Tighten fitting.
Torque: 14 N.m (124 in-lbs)
12. Rotate receiver-dehydrator splash shield into place and install push nut.
13. Lower vehicle.
14. Connect the electrical harness to the pressure sensor.
15. Install underhood junction block cover and hand tighten the screw.
16. Install battery hold-down retainer, locking the battery into the tray.
17. Install the hold-down retainer nut and screws.
Torque: 9 N.m (80 in-Lbs)
18. Install air cleaner housing cover and air induction hose.
19. Connect positive battery cable first.
Torque: 17 N.m (151 in-Lbs)
20. Connect negative battery cable last.
Torque: 17 N.m (151 in-lbs)
21. Evacuate, charge, and leak test A/C system.
22. Set clock to proper time if equipped.