SW2 L4-1.9L DOHC VIN 7 (1997)
5. Install front inner fender splash shield.
IMPORTANT: On left side, install rear section of shield first, then front. On right side, install front section of shield first, then rear.
6. Install tabs in body cut-out.
7. Align molded-in shield fasteners with holes in cradle. Push straight in to install.
8. Install push pins.
IMPORTANT: Make sure shield flaps are tucked in at body locations.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
9. Position wheel onto hub.
10. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
Torque: 140 Nm (103 ft. lbs.)
11. Lower vehicle from hoist.
12. Perform vehicle wheel alignment.
