SW2 L4-1.9L DOHC VIN 7 (1997)
9. Remove intake bracket to intake manifold bolt.
10. Remove intake bracket to intermediate shaft support bolt.
11. Remove two intermediate shaft to engine block bolts.
12. Carefully slide intermediate shaft out of transaxle.
13. Remove powertrain stiffening bracket bolts and remove bracket.
14. Remove three flywheel housing dust cover bolts and remove dust cover.
15. Remove axle seal using SA9133T.
a. Remove dust cover by prying out with a screw driver.
b. Remove seal by threading puller through steel seal body as close to outside diameter as possible.
INSTALLATION
1. Clean seal bore in housing.
2. Apply a light bead of Loctite(R) 515 Gasket Eliminator Sealant (P/N 21005993) or equivalent on the diameter of the seal that presses into the
bore.
3. Use tool SA9113T to install seal. Place seal on tool and be sure to keep seal lined up with bore during installation. (Automatic shown, manual
transaxle similar.)