VUE 2WD V6-3.5L VIN 4 (2004)
Important: Prior to disconnecting the brake pipes from the antilock brake system (ABS) modulator assembly, note the locations of the brake pipes to
the valve assembly, to aid during installation.
6. Disconnect the caliper and wheel cylinder brake pipes from the brake pressure modulator valve (BPMV).
7. Cap the brake pipe ends to prevent brake fluid loss and contamination.
8. Disconnect the master cylinder brake pipes from the BPMV.
9. Cap the brake pipe ends to prevent brake fluid loss and contamination.
10. Plug the modulator brake pipe openings to prevent brake fluid loss and contamination.
11. Loosen the 2 insulator nuts on the brake pressure modulator valve assembly.
12. Remove the brake modulator assembly from modulator bracket by pulling straight up.
Installation Procedure
Important: When installing a new brake modulator assembly, do NOT remove the shipping plugs from the pipe ports until after installation into the
vehicle.
1. Install the brake modulator assembly to the modulator bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Tighten the 2 brake pressure modulator assembly insulator nuts.
^
Tighten the nuts to 20 Nm (15 ft. lbs.).
