VUE AWD L4-2.2L VIN D (2005)
32. Carefully pull the camshafts straight up to avoid damaging the cylinder head thrust surfaces.
Installation Procedure
Notice: After cylinder block, head, or lifter replacement, it will be necessary to allow the engine to idle for 3-5 minutes. If the lifters are noisy, warm
the engine up at less than 200 RPM. After the coolant temperature has reached approximately 85°C (185°F), cycle the engine RPM from idle to 300
RPM for approximately 10 minutes or drive the vehicle 8 kilometers (5 miles) to purge the air. If the air cannot be purged, the faulty lifters will have
to be replaced.
Notice: Lifters that are pumped up may cause PCM misfire codes to set. Continue to operate the engine until the lifters bleed down. Using the scan
tool, clear the codes and malfunction history.
Notice: If a valve seal is removed after it has been installed, it must be discarded. The valve stem lock groove will cut the seal's lip during removal.
Use extreme care when installing valve retainers and do not damage the valve stems.
1. Allow the engine to idle.
2. Ensure install rocker arms are in their proper location, followers.
