VUE AWD L4-2.2L VIN D (2005)
Engine Mount: Service and Repair
Powertrain Mount Balance Procedure -Lower Mount
Powertrain Mount Balance Procedure -Lower Mount
Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
1. Raise and support the vehicle.
2. Loosen the front mount through bolt. Do not remove.
3. Loosen the rear mount through bolt. Do not remove.
4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
Notice: Refer to Fastener Notice in Service Precautions.
5. Tighten the rear motor mount through bolt.
^
Tighten the bolt to 110 Nm (81 ft. lbs.).