VUE AWD L4-2.2L VIN D (2005)
6. Loosen, do not remove the RH mount bolts.
7. Reposition the floor jacks to allow a 1/8 in gap between the mount and mount bracket
Notice: Refer to Fastener Notice in Service Precautions.
8. Tighten the LH mount starting with the center bolt.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
9. Tighten the RH mount starting with the center bolt.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
10. Remove the floor jacks.
11. Shake the powertrain Vigorously from front to rear and allow the powertrain to settle.