VUE AWD L4-2.2L VIN D (2005)
1. Make sure the rear main seal bore is free from debris. If a sealer is present, it must be removed to assure proper installation of the rear main seal.
2. Lubricate the outer diameter of the rear main seal with clean engine oil.
3. Using the J 42067, press the new seal into the housing until fully seated. The installer will control the depth of the seal installation.
4. Install the flywheel/flexplate.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install new flywheel bolts.
6. Install the J 43653.
7. Tighten the flywheel bolts.
^
Tighten the flywheel bolts L61 to 53 Nm (39 ft. lbs.) +25°.
8. Remove the J 43653.
9. If the vehicle is equipped with a manual transaxle.
10. Install the transaxle assembly.