VUE AWD L4-2.2L VIN D (2005)
26. Inspect the bore of the tensioner body for dirt, debris and damage. If any damage appears, replace the tensioner. Clean dirt of debris out with a lint
free cloth.
27. Install the compressed piston assembly back into the timing chain tensioner body until it stops at the bottom of the bore. Do not compress the
piston assembly against the bottom of the bore. If the piston assembly is compressed against the bottom of the bore, it will activate the tensioner,
which will then need to be reset again.
28. At this point, the tensioner should measure approximately 72 mm (2.83 inch) (1) from end-to-end. If the tensioner does not read 72 mm (2.83
inch) (1) from end to end repeat step 24
29. Ensure all dirt and debris is removed from the timing chain tensioner threaded hole in the cylinder head.
30. Install the new timing chain tensioner assembly bolt and tighten.
^
Tighten the timing chain tensioner assembly bolt to 75 Nm (55 ft. lbs.).
31. The timing chain tensioner is released by compressing it 2 mm (0.079 inch) which will release the locking mechanism in the ratchet. To release
the timing chain tensioner, use a suitable tool with a rubber tip on the end. Feed the tool down through the cam drive chest to rest on the cam
chain. Then give a sharp jolt diagonally downwards to release the tensioner.
32. Install the upper timing chain guide and bolts.
