VUE AWD L4-2.2L VIN D (2005)
Important: A new tensioner should be supplied in the fully compressed non-active state. A tensioner in the compressed state will measure 72 mm
(2.83 inch) (1) from end to end. A tensioner in the active state will measure 85 mm (3.53 inch) from end to end.
22. Inspect the timing chain tensioner. If the timing chain tensioner, O-ring seal, or washer is damaged, replace the timing chain tensioner.
23. Measure the timing chain tensioner assembly from end-to-end.
24. If the timing chain tensioner is not in the compressed state perform the following steps;
24.1.
Remove the piston assembly from the body of the timing chain tensioner by pulling it out.
24.2.
Install J45027-2 (2) into a vise.
24.3.
Install the notch end of the piston assembly into the J45027-2 (2).
25. Using J45027-1 (1), turn the ratchet cylinder into the piston.
26. Inspect the bore of the tensioner body for dirt, debris and damage. If any damage appears, replace the tensioner. Clean dirt of debris out with a lint
free cloth.
27. Install the compressed piston assembly back into the timing chain tensioner body until it stops at the bottom of the bore. Do not compress the
piston assembly against the bottom of the bore. If the piston assembly is compressed against the bottom of the bore, it will activate the tensioner,
which will then need to be reset again.
28. At this point, the tensioner should measure approximately 72 mm (2.83 inch) (1) from end-to-end. If the tensioner does not read 72 mm (2.83
inch) (1) from end to end repeat step 24
