VUE AWD L4-2.2L VIN D (2005)
Air Door Actuator / Motor: Service and Repair
Panel Actuator
PANEL ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel compartment.
2. Disconnect the electrical connector from the panel actuator.
3. Remove the panel actuator screws from the HVAC module.
4. Remove the panel actuator from the HVAC module.
INSTALLATION PROCEDURE
1. Align the panel actuator with the door shaft and rotate into position.
2. Install the panel actuator screws to the HVAC module.
Tighten the screws to 1 N.m (9 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the panel actuator.
4. Calibrate the mode actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module three times each, within two
seconds of initial push.
-
The A/C and RECIRC button LED's will flash while this calibration is taking place.
-
The calibration will take anywhere between 10 to 30 seconds depending on battery voltage.
-
The LEDs will quit flashing when the calibration is complete.