VUE AWD L4-2.2L VIN D (2005)
1. Install the HVAC control module to the center trim bezel.
2. Install the HVAC control module screws to the center trim bezel.
Tighten the screws to 2.5 N.m (22 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Center the temperature cable knob by inserting the assembly alignment tab into the centering slot of the temperature knob shaft.
4. Center the HVAC module temperature door by aligning the cable lug of the temperature control cable with the center point of the detent spring.
Detent spring force should hold the temperature door in the desired position.