VUE AWD L4-2.2L VIN D (2005)
5. Disconnect the PNP switch electrical connector (3) from the PNP switch (4).
6. Remove the PNP switch bolt (2) and stud (1).
7. Remove the PNP switch (4) from the transaxle.
Installation Procedure (Old Switch)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the PNP switch with the transaxle manual shaft and install the PNP switch.
3. Loosely install the PNP switch bolt (2) and stud (1).
4. Connect the PNP switch electrical connector (3).