VUE AWD L4-2.2L VIN D (2005)
3. Remove the stub axle shaft from the transaxle. Use the J 6125-1B and the J 38868.
4. Pull lightly on the shaft. Rotate the shaft until the output shaft snap ring at the differential seats in the taper on the differential side gear.
5. Remove inner snap ring.
6. Remove the right hand axle seal from the transaxle. Use the J 23129 and the J 6125-1B.
Installation Procedure
Important:
1. The stub axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.
2. Install the new seal. Use the J 41102. Lubricate the seal lip with a light wipe of transmission oil.
3. Important: Carefully guide the stub axle shaft past the lip seal. Do not allow the shaft splines to contact any portion of the seal lip surface,
otherwise damage to the seal will occur.
Install the two new snap rings on the stub shaft.
4. Install the stub shaft into the transmission. Use a mallet.
5. Install the right drive axle assembly.
6. Lower the vehicle.
7. Inspect the oil level. Refer to Transmission Fluid Checking Procedure. See: Testing and Inspection/Component Tests and General
Diagnostics/4T40-E/4T45-E Automatic Transaxle/Transmission Fluid Checking Procedure
8. Inspect the shaft and the seal for leaks.
Output Axle Shaft Sleeve and Seal Replacement
Output Axle Shaft Sleeve and Seal Replacement
