VUE AWD L4-2.2L VIN D (2005)
Tighten the bleed screw.
^
Tighten the screw to 7 Nm (62 inch lbs.).
2. Ensure the pedal is in the released position.
3. Fill the reservoir with DOT 3 hydraulic fluid to the MAX level (1).
4. Important: Brake fluid will deteriorate the rubber on the J45727. Use a clean shop towel to wipe away all fluid after each use.
Install the J45727 and attach to the J 23738-A or equivalent with a length of hose.
5. Place and hold the J45727 over the top of the reservoir to ensure a tight fit.
6. Operate the J 23738-A to achieve 51-68 kPa (15-20 hg) on the gage.
7. Hold vacuum for approximately 1 minute.
8. Slowly relieve vacuum and remove the J45727 from the reservoir.
9. Replenish fluid to the proper level.
10. Repeat steps 5-9 until all air is removed from the clutch system.
11. Replace the reservoir cap.
12. Important: The clutch pedal will go to the floor on the first actuation, but should improve on the following actuations.
Actuate the clutch pedal 10-12 times to ensure proper operation.
13. Road test the vehicle to ensure proper clutch operation and shifting.
