VUE AWD L4-2.2L VIN D (2005)
Clutch Slave Cylinder: Service and Repair
Clutch Actuator Cylinder Replacement
Removal Procedure
1. Disconnect the clutch master cylinder line from the transaxle by removing the C-clip.
2. Remove the transaxle.
3. Remove the clutch actuator cylinder bolts from the transaxle.
4. Remove the clutch actuator cylinder.
Installation Procedure
1. Important: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.
Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
2. Install the clutch actuator cylinder (1) to the transaxle.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the clutch actuator cylinder bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Install the transaxle.
