VUE AWD V6-3.5L VIN 4 (2004)
4. Remove master cylinder mounting nuts.
5. Remove the master cylinder from the vehicle.
6. Drain the master cylinder reservoir of all brake fluid.
Installation Procedure
1. Bench bleed the master cylinder.
2. Install the master cylinder to the brake booster.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the master cylinder mounting nuts.
^
Tighten the master cylinder mounting nuts to 25 Nm (18 ft. lbs.).
4. Remove the plugs from the brake pipes.
5. Connect the brake pipes to the master cylinder.
^
Tighten the brake pipe fittings at the master cylinder to 18 Nm (13 ft. lbs.).