VUE AWD V6-3.5L VIN 4 (2004)
1. Install the foam insulator the vacuum brake booster.
2. Install the brake booster to the vehicle
3. Install, but do not tighten, the booster mounting nuts.
4. Lightly lubricate the booster push rod pivot pin on the brake pedal with silicone lubricant.
5. Install the booster push rod to the pivot pin on the brake pedal.
6. Install the foam washer to the pivot pin.
7. Install the brake booster push rod retaining clip.
8. Fully seat the brake booster to the front of dash and the brake pedal assembly.
Notice: Refer to Fastener Notice in Service Precautions.
9. Tighten the vacuum brake booster mounting nuts.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).