VUE AWD V6-3.5L VIN 4 (2004)
Parking Brake Warning Switch: Service and Repair
Park Brake Warning Lamp Switch Replacement
Removal Procedure
1. Disable the SIR system.
2. Remove the front floor console.
3. Disconnect the warning lamp switch electrical connector (2).
4. Remove the warning lamp switch mounting screw (1).
5. Remove the switch from the park brake lever assembly.
Installation Procedure
1. Align the park brake warning lamp switch locating tab to the locating hole on the park brake lever assembly.
2. Install the switch to the park brake lever.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the park brake warning lamp switch mounting screw (1).
^
Tighten the screw to 4 Nm (35 inch lbs.).
4. Connect the park brake warning lamp switch electrical connector (2).
5. Install the front floor console.
6. Enable the SIR system.
7. Verify correct park brake warning lamp operation.
