VUE AWD V6-3.5L VIN 4 (2004)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the oil pressure sensor connector.
3. Remove the oil pressure sensor.
Installation Procedure
1. Apply sealant GM P/N 12346240 (Canadian P/N 10953493).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the oil pressure sensor.
^
Tighten the sensor to 18 Nm (13 ft. lbs.).
3. Connect the oil pressure sensor connector.
4. Lower the vehicle.