VUE AWD V6-3.5L VIN 4 (2004)
14. Remove the lower center pillar trim.
15. Remove the CPA from the seat belt pretensioner-LF connector.
16. Disconnect the seat belt pretensioner-LF connector.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the roof rail module-left, perform steps 3-8. To enable both the roof rail module-left and the seat belt pretensioner-LF, continue to step
3.
3. Connect the roof rail module-left connector to the vehicle harness connector.
4. Install the CPA to the roof rail module-left connector.
5. Install the rear coat hooks.
6. Install the rear headliner push-in retainers.
7. Install both the left and right rear corner garnish moldings.
8. Install the upper rear window molding.