VUE AWD V6-3.5L VIN 4 (2004)
4. Disconnect the secondary level sensor electrical connector.
5. Disconnect the suction port attaching tube by pressing down on the tab (1).
Notice: To prevent bending of the sending unit float arm during removal, lift the pump module up slightly to disengage the orientation tabs in the tank
and rotate the module 45 degrees.
6. Remove the secondary fuel pump module.
Important: Always replace the fuel pump module-to-tank seal, O-ring, when the fuel pump module is removed.
7. Discard the fuel pump module-to-tank seal.
8. If the fuel level sending unit is not being replaced as well, remove the fuel level sender.
Installation Procedure
1. If the fuel level sending unit is being replaced, install the fuel level sending unit into the new fuel pump.
