VUE AWD V6-3.5L VIN 4 (2004)
Transmission Temperature Sensor/Switch: Service and Repair
Transmission Fluid Temperature (TFT) Sensor Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the wiring harness from the transmission fluid temperature (TFT) sensor.
Important: Do not damage the TFT sensor or transaxle case.
3. Remove the TFT sensor bolt/screw.
4. Remove the TFT sensor and the O-ring.
Installation Procedure
1. Apply automatic transmission fluid to the new TFT sensor O-ring seal.
2. Install the new TFT sensor O-ring seal onto the TFT sensor.
3. Install the TFT sensor into the transmission case assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the TFT sensor bolt.
-
Tighten the output speed sensor bolt to 12 Nm (87 inch lbs.).
5. Connect the wiring harness to the TFT sensor.
6. Lower the vehicle.