VUE AWD V6-3.5L VIN 4 (2004)
3. Install the control arm ball stud into the steering knuckle.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Using the SA9140E, install the ball stud nut.
^
Tighten the nut to 60 Nm (44 ft lbs) for a ball stud with silver cup bottom or 40 Nm (30 ft lbs) for a ball stud with black cup bottom..
5. Tighten the strut to steering knuckle bolts and nuts.
^
Tighten the bolts and nuts to 180 Nm (133 ft. lbs.).
Important: Do not loosen the castle nut for cotter pin installation.
6. Tighten the castle nut enough to allow for cotter pin installation.
Important: The cotter pin must not contact the wheel speed sensor or drive axle.
7. Install the cotter pin.
8. Install the wheel bearing/hub assembly.